In the article the results of research of work of mine electric locomotive are driven on condition of stability of the system "A wheel is a rail" on coupling of wheels of electric locomotive with rails. It is marked that work of mine electric locomotive transport is conditioned by the row of specific terms. It is indicated that for realization of the electromechanics systems of mine electric locomotives structures are used with the hauling electric engines of direct and variable current. During working as of mine electric locomotive an important question there is coupling of wheels of electric locomotive with rails. Investigation of worsening of coupling of wheel with a rail is an origin of processes of skidding in the mode of creation of tractive or юза force in the mode braking of electric locomotive, that influence negatively for other knots of hauling electromechanic. In turn stability of the system "A wheel is a rail" depends on the type of hauling electromechanic. At consideration condition of stability of electromechanic on coupling of wheels of electric locomotive with rails important is inflexibility of descriptions of hauling electric motors. What more inflexibility, the higher stability of the system "A wheel is a rail". More hard descriptions can be got in the system of electromechanic with hauling asynchronous engines that give an opportunity to use this fact for realization of proportional distribution of efforts between the wheelpairs of electric locomotive. The systems ticker-coil on speed allow to carry out distribution of hauling and brake efforts that is attached to the wheelpairs of electric locomotive, in accordance with distribution of efforts from these wheelpairs on rails, only after the beginning of processes of skidding or skidding. For the decision of this problem a sufficient condition there is a limit of currents of hauling electric motors on the set level. In this connection possibility of distribution of hauling and brake efforts appears at any moment to time. For the decision of task of rational distribution of efforts of electric locomotive, distribution of forces was analysed between his wheelpairs in the function of total force that pulls an electric locomotive on his coupling. On the basis of analysis an idea was got about the redistribution of loading on the axes of electric locomotive. This distribution is in direct ratio to his total tractive force and coupling height, and in inverse ratio to inflexibility of corps. As a result, in order that propelling and brake forces on the axes of electric locomotive corresponded to distribution of weight on rails on wheelpairs, it is necessary to support identical correlation of weight and efforts on the axes of electric locomotive. The design of transients was conducted in the system of group electric hauling drive of mine electric locomotive in the mode of starting and braking. A design is executed for the engine of direct-current with successive connection of poles and hauling asynchronous engine. The charts of transients in the system of group electric hauling drive of mine electric locomotive in the mode of starting and braking showed absence of processes of skidding and slipping at application of the offered principle for the control system.
In the article the problem of identification the shading structure of solar panels is considered. The relevance of the study is conditioned by the necessity of rapid and…
This study is devoted to the development of a complex method for extracting the fetal electrocardiogram (fECG) from non-invasive abdominal recordings and for the…
This paper addresses the critical issue of power quality degradation in modern power systems caused by the proliferation of non-linear loads. The study focuses on the…
You may also start an advanced similarity search for this article.
