Mechanicaly Reconfigurable Antenna with Ionic-Polymer Metal Composite
This paper presents the possibility of employing an ionic polymer–metal composite (IPMC) actuator for coplanar waveguide fed antenna reconfiguration. Proposed antenna…
This article describes the properties of a photodetector module based on a photosensitive heterostructure with signal-shaping and amplifying stages, designed for the detection of ultraviolet (UV) radiation. The device employs a thin-film photosensitive metal-oxide/silicon (ZnO/Si) heterostructure combined with a signal-shaping stage based on two low-noise operational amplifiers (op-amp’s) and a comparator — LT118A and LT1716, respectively. A module comprising a monolithic sensing photoelement, a transimpedance amplifier (TIA), and a digital pulse comparator (DPC) was developed. At a bias voltage of 3 V, the heterostructure exhibits a sensitivity of 0.02 A/W at a wavelength of 365 nm. The photon-to-electron conversion efficiency in the UV range is quite high, yielding a signal-to-noise ratio of SNR = (Ilight-Idark) /Idark ≈ 320. A radiation detector with a two-stage amplifier — referred to as the photodiode module (PhDM) — was designed and simulated in the LTspice software environment. The UV radiation intensity threshold was set via a preset comparator signal level. During simulation, the photosignal was measured in both voltage-amplification and transimpedance-amplification modes. The device bandwidth was also analyzed, and the noise levels of the cascade were compared under dark conditions (dark-current mode) and under irradiation with a standard industrial light-emitting diode LED.
You may share and adapt this work, also commercially, if you give appropriate credit and share your adaptations under the same licence. View license terms ↗
Copyright (c) 2026 Іван В. Падалка, д-р фіз.-мат. наук проф. Ігор Степанович Вірт (Автор)
This paper presents the possibility of employing an ionic polymer–metal composite (IPMC) actuator for coplanar waveguide fed antenna reconfiguration. Proposed antenna…
To calculate the parameters of the Marx generator, such as the voltage at the generator output, the values of the circuit elements and, if necessary, the number of…
The interaction between metal nanoparticles and substrates under plasmonic resonance conditions plays a crucial role in various optical applications. In this study, we…
You may also start an advanced similarity search for this article.